29 Pedals OAMP
€339.00
Output-stage linedriver/buffer with up to +20 dB clean boost.
OAMP is an output driver designed to replace a conventional output buffer or gain pedal at the end of your chain. If you’re familiar with EUNA, it’s a similar concept but with a few key differences. High headroom, clean gain, great drive capability. They key features are labeled below. There are subtle tonal variations in the gain settings. Maximum clean output level is 20dB. 29dB of gain available. OAMP makes enough gain to drive your amp into breakup without adding it’s own distortion, or you can use it to trim hot signals from your pedalboard. The insert loop is active when OAMP is OFF, so you can easily swap from clean drive to a dirt pedal, alternative preamp or anything you want really. With nothing plugged into the insert OAMP is True-Bypass when switched off.
Specifications
| Highlights | Output linedriver/buffer, used end-of-chain before amp Up to +20 dB clean boost, 29 dB available Single 4 layer PCB with 2oz copper throughout Power supply side completely isolated from audio signal 1% thin-film resistors, WIMA film caps and other audiophile-grade components Handbuilt in USA |
| Bypass | True bypass |
| Power consumption | 7.5-35V AC/DC, center negative or positive* (power supply sold separately) 100 mA *Just use 9V DC center negative, 100 mA if you're in doubt |
| Dimensions | H: 5,3 cm (incl. switch) W: 12,5 cm D: 9,2 cm |
| Weight | 528 g. |
